fokikc.blogg.se - Opensprinkler pi setup

Opensprinkler pi setup install#
Opensprinkler pi setup software#
Opensprinkler pi setup code#
Opensprinkler pi setup password#

Normally it is .1, where “ x” is a number between 1 and 254.

Nave in mind an IP address for the OSPi network access point.

Opensprinkler pi setup password#

Note that the password should be at least 8 characters long. Have in mind a different name (wpa-ssid) and password (wpa-psk) for your OSPi network that you’ll configure.Have available the name (wpa-ssid) and password (wpa-psk) of the Internet-connected LAN.If the RPi is freestanding (for all but the final boot), connect powered 5V USB adapter to the RPi.If the RPi is attached to the Open Sprinkler board, connect the powered 24VAC adapter to the OS board.You can boot the RPi according to your preferred hardware configuration: The keyboard and monitor are connected directly to the RPi.

Opensprinkler pi setup install#

(You can install the RPi on the OS board at the end of the ad hoc setup.)

installed on the Open Sprinkler board, or.The microSD card has the Stretch version of Raspian installed on it, and the microSD card is installed in the RPi.Access (at least temporary) to the Internet via WiFi.git-core (Installed in these instructions).Random number tools (Installed in these instructions).Raspbian Stretch Lite (Installed prior to these instructions).I’ve successfully set up a Raspberry Pi Zero W, but Pi versions 2 (with WiFi dongle) or 3 should work fine. A standard 24VAC power supply for sprinkler valves.An Open Sprinkler Pi (OSPi) board from Open Sprinkler.Have the following requirements in place before proceeding.

You can set up an ad hoc network for any number of purposes. Note that there’s nothing in the present network setup instructions that’s Open Sprinkler specific. This source site also has more explanations of commands that is presented in the present document, and additionally includes a useful troubleshooting section. This Web site has the only set of Pi ad hoc network configuration instructions I’ve found that works for the Stretch version of Raspian. However, you don’t believe you’re administering device will always be within range of the OSPi network when needed, then this setup isn’t likely for you.Īll steps in the present OSPi network setup procedure below are directly distilled from this Stack Exchange Web page. I’ve found that I can connect to the OSPi network (even one using a Pi Zero W) with my iPhone and laptop up to 50′ away, with several intervening house walls. The OSPi network would be out of range of an administering device.

Opensprinkler pi setup code#

(This isn’t an important factor, though, since the current Raspian and Open Sprinkler code is quite stable.)

Opensprinkler pi setup software#

You can’t easily upgrade/update the OSPi software when you have an OSPi network, since upgrades are normally conducted over the Internet.

You need frequent in-place software/firmware upgrades.

Similarly, you can’t have log files forwarded to you. They aren’t connected to the Internet, and hence you can’t administer devices on them via the Internet. Ad hoc networks are by definition standalone. For example, you might have a rental property, whose grounds are watered by an OSPi system, and you don’t want the unreliability (or liability) of connecting the OSPi to the tenant’s WiFi network. In some cases, an existing WiFi network isn’t practical to access.

The existing WiFi network isn’t useable.

An OSPi network is useful in cases where there is no existing network Why would you do this?Ĭonsider setting up an OSPi ad hoc network (we’ll call this the OSPi network) if: Once you connect to the network, you open the Open Sprinkler App (or Web UI if using a laptop) to administer Open Sprinkler.